Aero Systems

Augen Technologies Aero Component & Electrical System Solutions group provides world class design & development support for aircraft bracket design support & Electrical systems.

Augen Technologies helps suppliers throughout their entire development cycle by providing solutions to meet their stringent budget & time constraints which puts immense pressure on the aircraft component & subsystem manufacturers to match tight development schedules of the OEMs.

Augen Technologies helps suppliers throughout their entire development cycle by providing solutions to meet their stringent budget & time constraints which puts immense pressure on the aircraft component & subsystem manufacturers to match tight development schedules of the OEMs.
 

Bracket Design:

Detail design of Brackets (ATA-53) for

  • Air-conditioning(ATA-21), Water Supply & Waste Water
  • (ATA-38), Oxygen Supply (ATA-35)
  • Frame drawings for Electrical and Mechanical Brackets.
  • Drafting of Parts and Assembly
  • Quality Checking of Interface Points, Part/Assembly Design & Drawings
  • Brackets design for sheet metal bend parts or transformed parts or may be a milled bracket
  • Solution for Non-Conformity Check

 

E3D Design:

  • Electrical Routing(SAM Design)
  • Installation Research & MAP
  • BM-Creation & Incorporation
  • eNDP-wave-II
  • DIP(Design Integration Plateau)
  • DTR(Design Technical Review)
     

Piping & Ducting Design:

Augen has experience working on Piping related software tools (Catia V4/V5, VPM, Dvise, Rosy)

The piping designers can route, modify and analyze piping and tubing networks.

During the routing of the piping and tubing, the engineer can focus on parameters and routing constraints of the pipe, letting the system manage the related geometry.

The engineer can route new piping lines and insert additional piping parts in existing lines

Following are the areas where Tubing and Piping design can be executed

  • ATA21 Air-condition/Supp. Cooling Sys.
  • ATA29 Hydraulic
  • ATA35 Oxygen
  • ATA38 Waste water
  • ATA26 Fire control

 

Standards known:

ATA 53 – Structures Design (Primary & Secondary)
ATA 92 – E3D (Electrical Wire Harnessing)
ATA 21 – Air conditioning
ATA 38 – Water Supply & Waste Water supply
ATA 35 – Oxygen Supply
ATA 26 – Fire Control
FAR & JAR – Stress Analysis & Stress Reports